Types R1Y and R1E: Paddle flow switches, reed switch contact, 1/2" male thread

Main uses:  Cost effective simple flow switch developed for swimming pool application. For water flow detection on vertical dia 63mm water pipes, upstream flow

Functional principle:

Balanced magnetic pallet mounted perpendicular to the flow and activating a reed switch through the wall. The return of the pallet is by gravity, without spring. No seal or liquid can pass between the piping system and the electrical contact. No metal parts (shaft, spring) in contact with the liquid. Suitable for corrosive water pools and spas and salination chlorination and bromination systems. Not be used for water containing magnetic particles or high viscosity liquids, which block the movement of the pallet.

Main housing material: Polypropylene, resistant to ozone and water disinfection products, usable with potable water.

Paddle: Polypropylene, 17 mm width

Paddle shaft: Polypropylene

Electrical rating: Max 1A, Max 70W, Max 250V, resistive load. Use on inductive circuits reduces electrical rating. We recommend to protect the reed switch with contact protection device when used in inductive loads

Electric contact type: Normally close, open by flow rise

Liquids compatibility: For use with clean water and liquids without magnetic particles and without chemical incompatibility with  polypropylene

Nominal pressure at 20°C: 1MPa (PN10)

Nominal diameter: Can be used on 55 to 63 mm internal diameter pipes.

The paddle is not cleavable.

Mandatory mounting position: On vertical pipes, with horizontal flow switch axis, and paddle upside.  Upstream flow only.

Water pipe connection:  On female ½” fitting.

On the type with BSPP thread, a NBR gasket is supplied with the product. On the type with NPT thread, thread sealant must be used Recommended torque: 7Nm

Liquids temperature range: 5 to 80°C

Ambient temperature range: 5 to 50°C

Ingress protection: IP65

Electrical connection: 2 x AWG24 (0.2mm²) cable, PVC insulation, T80°, style UL2464.

Installation instructions:

– Check carefully the paddle orientation: The arrow on housing must be exactly parallel to the pipe

– A 5 mm minimum gap must be respected between end of the paddle and tube wall opposite to the fitting.

– We recommend the use of nozzles of length less than or equal to 18mm between the gasket seat and the inside of the tube and with  an inner diameter greater than or equal to 20 mm, to avoid blocking of the pallet

Accessories: 1/2″ PVC saddles for DN40 to DN100 (OD) PVC pipes, and other fittings: see last section of this catalogue

Options: cable with connector or terminals, other cable length

 

Main references

Thread

Cable length

500mm

1m

2m

½BSPP

R1Y622768F45P050 R1Y622768F45P100 R1Y622768F45P200
½NPT R1E622768F25P050 R1E622768F25P100

R1E622768F25P200

PDF

2D&3D Drawing