Over-molded thermostat on heat tracing cable, type 49C

Technical features

The assembly is waterproof, frost proof, short immersion proof, protects the connection of the power cord to the thermostat, protects the thermostat housing and the connection between the thermostat and the heating cable, and starts the defrost when the temperature drops to a nearly freezing temperature. The flexibility of the over-molding must be compatible with the heating cable. The thermostat is mounted on a pipe, with its sensitive disc located thereon. He is secured there with nylon cable ties.

The temperature sensitive cup is made in stainless steel and is not covered by the over-molding, to optimize the temperature measurement and the response time. The free end of the heating cable must also receive an over-molding to make it waterproof.

This type of assembly is cost saving, but requires M.O.Q of 500 pieces.

The design and quotation of this product are only made on the basis of customer’s specs, and depend on the dimensions of the heating wire (diameter, length, power), the thermostat open and close temperatures, and type, gauge and length of the cord.

Defrost termination over-molded thermostat type 49JE

Technical features

The assembly is waterproof, frost proof, short immersion proof, protects the connection of the power cord to the thermostat, protects the thermostat housing and is terminate the defrost when the temperature rise to a warm temperature. The thermostat is mounted on a heat exchanger or on a pipe, with its sensitive disc located thereon. He is secured there with a spring or with a bracket.

The temperature sensitive cup is made in stainless steel and is not covered by the over-molding, to optimize the temperature measurement and the response time.

This type of assembly is cost saving, but requires M.O.Q of 500 pieces.

The design and quotation of this product are only made on the basis of customer’s specs, and depend on the thermostat open and close temperatures, and type, gauge and length of the cord.

Over-molded junction between cord and heat tracing cable, type 9DHT

Technical features

The assembly is waterproof, frost proof, short immersion proof, protects the connection of the power cord to the heating cable. The flexibility of the over-molding is compatible with the heating cable. The free end of the heating cable receives also an over-molding to make it waterproof.

This type of assembly is cost saving, but requires M.O.Q of 500 pieces.

The design and quotation of this product are only made on the basis of customer’s specs, and depend on the dimensions of the heating wire (diameter, length, power), and type, gauge and length of the cord.